Fujitsu Siemens Computers pmn User Manual page 479

Centricstor v3.1d user guide
Table of Contents

Advertisement

Explanation of console messages
SXPL048
PLM(#48): NOTICE: <num> cleancycles for tape-library <name> available again
Meaning
PLM(#45) has been correctly responded to?
SXPL049
PLM(#49): WARNING: ejected PV <name> of tapelibrary <name> is needed for
restore !
Meaning
The PV of a vault group has been removed from the robot, but is now required for a restore
job.
Response
The PV must be imported.
SXPL050
PLM(#50): NOTICE: PV <name> of tapelibrary <name> is ready for eject !
Meaning
Information that this PV of a vault group can be removed from the robot.
SXPL051
PLM(#51): ERROR: <pds> reports errno = <num> ( <string> ) on PV <name>
Meaning
The PDS has detected an error.
Response
Check PDS.
SXPL053
PLM(#53): NOTICE: writing of directory failed for PV <name> on PDS <name> !
Meaning
Error when writing the tape directory. Possible causes: No space available on the tape or
tape damaged. This is normally not a problem; only in the event of a disaster recovery does
the time for reading in the physical volume increase.
Response
Check whether the PV is defective.
SXPL054
PLM(#54): WARNING: PV <name> of tapelibrary <name> is inaccessible !
Meaning
The PLM does not have access to the physical volume. Further VLM restore requests for
logical volumes on this physical volume are rejected with PLM_RELV_PVAC_ERR.
Response
Check the robot for why the access failed.
SXPL055
PLM(#55): WARNING: Capacity of PV <PV-name> is too small for PVG <PVG-name>;
PV-file will be removed!
Meaning
The capacity of the cartridge which was reported during initialization is not sufficient. It must
be at least twice as large as the largest LV that is to be saved in this group.
U41117-J-Z125-7-76
Message lines
479

Advertisement

Table of Contents
loading

This manual is also suitable for:

Centricstor v3.1d

Table of Contents