Procedures; Creating The Centricstor Data Maintenance - Fujitsu Siemens Computers pmn User Manual

Procedures

2.6 Procedures

2.6.1 Creating the CentricStor data maintenance

Initial situation:
To start CentricStor, the PLM and VLM data maintenance facility must be created:
CSC
MAREN
LV0000
LV0001
LV0002
LV0003
Figure 13: CentricStor after the VLM and PLM data maintenance have been created
1. The names of the logical volumes which are to be loaded into the RAID disk array later
are entered in the VLM data maintenance (see the
» Add Logical Volumes" on page
In the example, these are the logical volumes LV0000 to LV2000. These volumes still
do not contain any data.
2. The names (VSNs) of the physical volumes present in the robots which are to be used
in CentricStor are entered in the PLM data maintenance (see the
Volume Operations » Add Physical Volumes" on page
the volumes PV0000 to PV0100.
3. The logical volumes are made known in BS2000/OSD (example of a storage location:
"VTLSLOC").
CentricStor is then ready for operation.
38
CentricStor is installed and configured. As yet, there is no data on the
RAID system. The tape cartridges of the robots are blank.
LV0000
LV0001
Host
LV0002
LV0003
LV0004
LV0005
LV0006
LV0007
LV0008
LV0009
LV0010
LV0011
BS2000
ROBAR
3
CentricStor
VLM PLM
PV0000
PV0001
2
1
PV0002
PV0003
PV0004
PV0005
PV0006
PV0007
PV0008
PV0009
PV0010
PV0011
RAID
Logical volumes
211).
CentricStor - Virtual Tape Library
Robots
Tape drive
Physical volumes
PV0012
PV0009
PV0006
PV0003
PV0000
PV0000
PV0000
PV0007
PV0004
PV0001
PV0000
PV0000
PV0008
PV0005
PV0002
section "Logical Volume Operations
section "Physical
223). In the example, these are
U41117-J-Z125-7-76