2
Make sure the machine is ready to send ➞ press [Stamp].
A check mark (
) appears in the box to the left of [Stamp].
NOTE
To cancel the Stamp mode, press [Stamp] again.
3
Specify the destination ➞ press
Scanning starts.
A stamp mark (
) appears on the original.
NOTE
•
For instructions on specifying the destination, see "Dialing Methods," on p. 2-16.
•
If the stamp is not marked clearly, see Chapter 7, "Routine Maintenance," in the
Reference Guide.
(Start).
Sending Methods
2
2-15