Operations Flow - Panasonic WJ-HD616/1000 Installation Manual

Operations flow

The operation flow of the recorder is as follows.
z
Rack mounting
x
Connections
Installation of the hard disk drives
c
(+ Page 52)
Determination of the operational mode
v
(+ Page 54)
b
Startup
Configuration of the settings for the
n
quick setup.
Configuration of the recording area
m
setting of the hard disk drives.
Page 126)
,
Setup
(+ Page 57)
Start operation
When necessary
Replacement/addition of hard disk
.
drives
(+ Page 28)
(+ Page 29)
(+ Page 55)
(+ Page 63)
(+
(+ Page 133)
z Install the recorder in the rack.
Go to step x when not installing it in the rack.
x Connect the recorder to each device.
When using an optional extension unit, install hard disk
drives in the optional extension unit (WJ-HDE400) and
connect to the recorder. (+ Page 33)
c Install hard disk drives in the recorder.
When using an optional RAID board (WJ-HDB601) or an
optional DVD drive (WJ-HDB611), install it.
v Reboot the recorder after determining the operational
mode if necessary such when using the RAID function.
When not installing an optional RAID board
(WJ-HDB601), go to step 5.
b Turn on the power of the recorder.
When using optional extension units (WJ-HDE400), turn
the power of all the extension units before turning on the
power of the recorder.
n Configure the settings such as the current time and date
setting, schedule recording settings, etc.
m Change the recording area setting or format the record-
ing area of the hard disk drive if necessary such when it
is necessary to assign the event recording area to the
hard disk drive.
, Configure the settings required for operation.
The hard disk drives can be formatted/replaced without turn-
ing off the power of the recorder even when one of them
becomes faulty.
27