Rear View - Panasonic WJ-HD616/1000 Installation Manual

Note:
• After attaching the front cover to the recorder, be sure to
turn on the power of front cover.

■ Rear view

!2 !3
q Alarm/Control connector (D-sub 25-pin) [ALARM/
CONTROL]
Connect a control switch to control the recorder using
an external device such as a buzzer or a lamp.
(+ Page 44)
w Alarm connector (D-sub 25-pin) [ALARM]
Connect an external device such as a sensor, door
switch, etc. to this connector. (+ Page 48)
e External storage connector 1-3 [EXT STORAGE]
Connect the optional extension unit (WJ-HDE400) to this
connector using the dedicated connection cable provid-
ed with the extension unit. (+ Page 33)
r Mode switch [MODE]
Determine the operational mode of the recorder using
this switch. (+ Page 51)
t DATA port [DATA]
Connect a PS·Data compatible device to this port.
(+ Page 35)
y RS485 port [RS485/CAMERA]
Connect an RS485 combination camera to this port.
(+ Page 42)
u Network port [10/100BASE-T]
Connect this recorder to a network (10BASE-T/
100BASE-TX) using this port. When the recorder is con-
nected to a network, it is possible to operate the record-
er from a PC via a network.
22
q w e r
MODE
EXT STORAGE
3 2 1
1 2 3 4 5 6 7 8
1
MONITOR
OUT
ALARM
2
2
ALARM/CONTROL OUT-CASCADE-IN CASCADE IN
16 15 14 13 12 11 10 9
IN
OUT
16 15 14 13 12 11 10 9
VIDEO
!4 !5
t y u
DATA RS485(CAMERA) 10/100BASE-T
2 1
3 1
IN
CASCADE
1 2 1
OUT
4 2
AUDIO
OUT MONITOR OUT(HD) AUDIO IN OUT
8 7 6 5 4 3 2 1
7
1
OUT
8 7 6 5 4 3 2
AC IN
!6 !7 !8 !1
i Audio cascade input/output connector (RCA pin
jack) [CASCADE IN, OUT])
Use this connector for audio output from another record-
er when it is connected in cascading connection.
o SIGNAL GND terminal
Connect this terminal to the SIGNAL GND terminals of
the devices in the system for signal ground. When oper-
ating the recorder and the devices in the system without
signal ground, oscillation or noise may be produced.
!0 Power button [POWER]
Press this button to turn on/off the power of the record-
er. When this button is pressed again, the operation is
finished and the power is turned off.
!1 Power inlet [AC IN]
Connect the provided power cord to this inlet. The
power plug is a 2-conductor plug with grounding termi-
nal type.
!2 Video input connector 1 to 16 (BNC)
[VIDEO IN 1 to 16]
Connect system cameras and combination cameras to
these connectors. When connecting combination cam-
eras, connect them to the video input connector 1-8
(coaxial communication compatible).
!3 Video output connector 1 to 16 (BNC, active loop
through) [VIDEO OUT 1 to 16]
Images input to the video out connectors 1-16 will be
output from these connectors. When the power is off,
images will not be output to the video output connector
1-16.
i
POWER
ON
!0
OFF
SIGNAL
GND
o