Panasonic WJ-HD616/1000 Installation Manual page 46

Connection for the auto time adjustment function (1)
When "Master" is set for "Auto time adjustment" on the [Time & date] tab under the "Basic" page of the setup menu
"Time adjustment signal output" becomes available and the clock of this recorder will be applied to other devices.
The time adjustment signal output will be generated from pin no. 20 (time adjustment I/O) at the time set for "Activation time"
(Signal ground)
13
ALARM/CONTROL
Connection for the auto time adjustment function (2)
When "Slave" is set for "Auto adjustment time" on the [Time & date] tab under the "Basic"page of the setup menu
"Time adjustment signal input" becomes available and the clock of the other device will be applied to this recorder.
When a signal output from the other device is supplied to the time adjustment I/O terminals (pin no. 20) 15 minutes before/after
the time set for "Activation time", the clock of the recorder will be set to the time set for "Activation time".
Example:
When "15:00" is set for "Activation time"
• Signal is supplied at 2:50:00 (hour:minute:second) pm → Set at 3:00:00 pm
• Signal input supplied at 3:14:45 pm → Set at 3:00:00 pm
• Signal is supplied at 3:20:00 pm → Time will not be adjusted.
(Signal ground)
13
ALARM/CONTROL
Important:
• When "Slave" is selected, the clock will not be adjusted during event recording or emergency recording.
46
(Time adjustment signal output)
20
(Time adjustment signal output)
20
Terminal of the other device
Output for the
indicators on
the front panel
Terminal of the other device
Output for the
indicators on
the front panel