Table of Contents
Advertisement
5. Install the microprocessor:
a. Touch the static-protective package containing the new microprocessor to
any unpainted metal surface on the server; then, remove the microprocessor
from the package.
b. Orient the microprocessor over the microprocessor connector, as shown in
the following illustration. Carefully press the microprocessor into the
connector.
Terminator card
Microprocessor 2
Attention: To avoid bending the pins, do not use excessive force when
pressing the microprocessor into the connector.
6. Push the release lever down to lock the microprocessor into place.
7. If you are installing a microprocessor that has a speed of 933 MHz or higher,
continue with step 9 on page 77.
If you are installing a microprocessor that has a speed lower than 933 MHz,
continue with step 8 on page 76.
Microprocessor 2
connector
Microprocessor
orientation indicator
Lever
75
Installing options
Advertisement
Table of Contents
