Table of Contents
Advertisement
12. Remove the right-side cover.
Right-side cover
Figure 10. Removing the right-side cover
13. Install the new bottom cover that comes with the conversion kit.
Figure 11. Installing the new bottom cover
46
Hardware Maintenance Manual: xSeries 220 Type 8645
a. From the rear of the system, remove the four screws that hold the
right-side cover in place. Save all four screws for installing the new bottom
cover.
b. Slide the right-side cover toward the rear of the system to remove it. Store
the cover for possible future use.
a. Carefully turn the system so that the cover-release-latch side is down on a
flat surface; then, align the bottom cover with the frame of the system.
b. Slide the cover toward the front of the system, making sure that the tabs
on the front and rear of the cover fit into the slots on the system.
Bottom cover
Bottom cover screws
Power supply
screw
Advertisement
Table of Contents
