Table of Contents
Advertisement
Note: Ensure that the tabs on the back of the cover fit into the slots on the
back of the system. Be sure that the front edge of the cover is flat
against the system.
Figure 7. Installing the top cover
11. Turn the system back to the tower-orientation; then, remove the top handle.
a. Carefully use a flat-blade screwdriver to push in the tabs inside the plastic
cover on the top of the system; then, remove the plastic cover and store it
for possible future use.
Figure 8. Removing the plastic cover from the handle
b. Grasp the metal handle and slide it backwards until you can lift it away
from the system. Store the metal handle for possible future use.
Figure 9. Removing the top handle
45
Tower-to-rack conversion
Advertisement
Table of Contents
