Table of Contents
Advertisement
5. If the drive is a laser product, observe the following safety precaution.
CAUTION:
When laser products (such as CD-ROMs, DVD drives, fiber optic devices, or
transmitters) are installed, note the following:
v Do not remove the covers. Removing the covers of the laser product could result
in exposure to hazardous laser radiation. There are no serviceable parts inside the
device.
v Use of controls or adjustments or performance of procedures other than those
specified herein might result in hazardous radiation exposure.
DANGERSome laser products contain an embedded Class 3A or Class 3B laser diode.
Note the following. Laser radiation when open. Do not stare into the beam, do not
view directly with optical instruments, and avoid direct exposure to the beam.
6. Touch the static-protective bag containing the drive to any unpainted metal
surface on the server; then, remove the drive from the bag and place it on a
static-protective surface.
7. Set any jumpers or switches on the drive according to the documentation that
comes with the drive.
8. Push the drive into the bay.
9. If the drive is an IDE device, plug one connector of the IDE cable into the
back of the drive and the other end of the cable into the IDE connector (J30)
on the system board.
If the drive is a SCSI device, plug one connector of the SCSI cable into the
back of the drive and make sure that the other end of the cable is connected
to the SCSI connector (J41) on the system board.
Note: Ensure that you route the SCSI cable so that it does not block the
airflow to the rear of the drives or over the microprocessors.
10. Connect a power cable to the back of the drive. The connectors are keyed and
can be inserted only one way.
11. If you are installing another drive, do so now. Otherwise, continue with the
next step.
12. If you have other options to install or remove, do so now; otherwise, replace
the cover (see "Installing the cover" on page 79 for details).
67
Installing options
Advertisement
Table of Contents
