Table of Contents
Advertisement
16. To install the new system bezel that comes with the conversion kit, align the
Figure 14. Installing the new system bezel
17. Install the release-latch-bracket assemblies on the system.
Figure 15. Installing the release-latch-bracket assemblies
48
Hardware Maintenance Manual: xSeries 220 Type 8645
tab on the back of the bezel with the tab opening on the left-front of the
system; then, swing the bezel toward the system and press until it snaps into
place.
a. Align the bracket marked with an L with the holes on the left side of the
system; then, use two M3.5 screws to attach the bracket to the system.
Release-latch-bracket assembly
b. Repeat this step to install the other release-latch-bracket assembly on the
right side of the system.
Advertisement
Table of Contents
