IBM 8645 - Eserver xSeries 220 Hardware Maintenance Manual page 48

Figure 1. Removing the left-side cover
40
Hardware Maintenance Manual: xSeries 220 Type 8645
Key lock
6. Remove the support bracket assembly.
a. If there is a fan attached to the support bracket assembly, note where the
fan cable is connected to the system board; then, disconnect the fan cable
from the system board.
Note: Refer to the system service label for system board connector
locations.
b. Grasp the rear of the support bracket assembly and rotate it away from the
system.
Cover-release
latch