Table of Contents
Advertisement
c. Use three of the screws that you removed earlier to secure the bottom
cover; then, use the fourth screw to secure the power supply.
14. If your system has hot-swap drives installed, remove the hot-swap drive bay
filler panel from the new bezel that comes with the conversion kit.
Note: Attach the SCSI ID label that comes with the conversion kit on the front
of the bezel, just above where you removed the hot-swap drive bay
filler panel.
Hot-swap drive
bay filler panel
Bezel
Figure 12. Removing the hot-swap drive bay filler panel from the bezel
15. If your system does not have USB support, install the USB bezel insert over
the empty USB-block on the front of your system.
a. Align the top of the USB bezel insert with the top of the USB-block. Make
sure that the side of the USB bezel insert that will extend into the new
system bezel is facing away from the system.
Figure 13. Installing the USB bezel insert
b. Rotate the bottom of the USB bezel insert toward the server; then, push
until it snaps into place.
USB bezel insert
47
Tower-to-rack conversion
Advertisement
Table of Contents
