Table of Contents
Advertisement
Error Code/Symptom
188 (Bad EEPROM CRC #2)
189 (Three attempts were
made to access the server
with invalid passwords)
201 (Memory test error, see
"Memory Settings" on page
32.) If the server does not
have the latest level of BIOS
installed, update the BIOS to
the latest level and run the
diagnostic program again.
229 (Cache error)
289 (DIMM has been disabled
by user or system, see
"Memory Settings" on page
32.)
301 (Keyboard or keyboard
controller error)
303 (Keyboard controller
error)
602 (Invalid diskette boot
record)
604 (Diskette drive error)
662 (Diskette drive
configuration error)
962 (Parallel port error)
11XX (System board serial
port 1 or 2 error)
1162 (Serial port
configuration conflict)
1200 (microprocessor machine
check)
114
Hardware Maintenance Manual: xSeries 220 Type 8645
FRU/Action
1. Run Configuration/Setup
2. System Board
1. Run Configuration/Setup, enter the administrator password
2. System Board.
1. Run memory diagnostics.
2. DIMM
3. System Board
1. Microprocessor
2. Optional microprocessor (if installed)
1. Run Configuration/Setup, if disabled by user
2. Disabled DIMM, if not disabled by user.
1.
Keyboard
2. System Board
1. System Board
2. Keyboard
1. Diskette
2. Diskette Drive
3. Cable
4. System Board
1. Run Configuration/Setup and Diagnostics
2. Diskette Drive
3. Drive Cable
4. System Board
1. Run Configuration/Setup and Diagnostics
2. Diskette Drive
3. Drive Cable
4. System Board
1. Disconnect external cable on parallel port.
2. Run Configuration/Setup
3. System Board
1. Disconnect external cable on serial port.
2. Run Configuration/Setup
3. System Board
1. Disconnect external cable on serial port
2. Run Configuration/Setup
3. System board
1. Microprocessor
Advertisement
Table of Contents
