Table of Contents
Advertisement
Error Code/Symptom
011-XXX-001 (Failed COM2
Serial Port test)
014-XXX-000 (Failed Parallel
Port test)
015-XXX-001 (USB interface
not found, board damaged)
015-XXX-015 (Failed USB
External Loopback test)
015-XXX-198 (USB device
connected during USB test)
020-XXX-000 (Failed PCI
Interface test)
030-XXX-000 (Failed Internal
SCSI interface test)
030-XXX-00N (Failed SCSI
test on PCI slot N. Check
system error log before
replacing a FRU.)
035-XXX-099
035-XXX-S99 (Failed RAID
test on PCI slot S. S =
number of failing PCI slot.
Check System Error Log
before replacing a FRU.)
035-XXX-SNN (Check System
Error Log before replacing a
FRU. S = number of failing
PCI slot; NN = SCSI ID of
failing fixed disk.)
035-253-S99 (RAID adapter
initialization failure)
075-XXX-000 (Failed Power
Supply test)
089-XXX-001 (Failed
Microprocessor test)
089-XXX-002 (Failed Optional
Microprocessor test)
180-XXX-003 (Failed System
Board LED test)
201-XXX-0NN (Failed
Memory test, see "Memory
Settings" on page 32.) NN =
DIMM location.
FRU/Action
1. System Board
1. System Board
1. System Board
1. Make sure parallel port is not disabled
2. Re-run USB External Loopback test
3. System Board
1. Remove USB devices from USB1 and USB2
2. Re-run test
3. System Board
1. System Board
1. System Board
1. Adapter in Slot N
1. No adapters were found.
2. If adapter is installed re-check connection.
1. Adapter
2. SCSI Backplane
3. Cable
1. Fixed Disk with SCSI ID NN on RAID adapter in PCI slot S.
1. ServeRAID Adapter in slot S is not configured properly. Obtain the basic and
extended configuration status and refer to the ServeRAID Hardware Maintenance
Manual for more information.
2. Cable
3. Adapter
1. Power Supply
1. Microprocessor
1. Optional Microprocessor 2
1. System Board
1. DIMM Location J1-J4
2. Memory card
109
Symptom-to-FRU index
Advertisement
Table of Contents
