NOTE
Cisco Small Business RV0xx Series Routers Administration Guide
Editing a DMZ Connection
Use the Edit DMZ Connection page to specify the settings for your DMZ. DMZ is
enabled by default.
IPv4
IPv6
The Edit DMZ Connection page appears after you click the Edit icon in the DMZ
Setting section of the Network page.
Before navigating away from this page, click Save to save your settings, or click
Cancel to undo them. Any unsaved changes are abandoned.
If you are using IPv4 addressing, enter the following information:
•
Subnet: Choose this option to place the DMZ on a different subnet than the
WAN (default setting). Enter an IP address and subnet mask for the DMZ.
•
Range: Choose this option to place the DMZ on the same subnet as the
WAN. Enter the range of IP addresses to reserve for the DMZ port.
3
38