Bandwidth Management
Creation of New Bandwidth Management Rules
STEP 11
STEP 12
STEP 13
Creation of New Bandwidth Management Rules
STEP 1
STEP 2
Cisco Small Business RV0xx Series Routers Administration Guide
Enter the RTP port range in the
incoming and outgoing traffic. For example, you can set the Port Range to 10000 to
25000 to make sure that all active ports are covered.
Click Add to List.
Click Save to save your changes.
Create four new rules: Vonage VoIP (Upstream), Vonage VoIP (Downstream),
Vonage 2 (Upstream), and Vonage 2 (Downstream).
Set up a rule for upstream bandwidth for Vonage 1:
Bandwidth Management
a. On the
drop-down menu.
b. Enter the IP address or range you need to control. To include all internal IP
addresses, keep the default value.
Direction
c. From the
Min. Rate
d. In the
field, enter the minimum rate for the guaranteed bandwidth. For
example, you can set a minimum rate of 40 kbit/sec.
Max. Rate
e. In the
field, enter the maximum rate for the maximum bandwidth. For
example, you can set a maximum rate of 80 kbit/sec.
f.
Select Enable to enable this rule.
g. After you have set up the rule, click Add to list.
Set up the rule for downstream bandwidth for Vonage 1.
a. Select Vonage VoIP from the
b. Enter the IP address or range you need to control. To include all internal IP
addresses, keep the default value.
Direction
c. From the
Min. Rate
d. In the
field, enter the minimum rate for the guaranteed bandwidth. For
example, you can set a minimum rate of 40 kbit/sec.
Port Range
page, select Vonage VoIP from the
drop-down menu, select Upstream for outbound traffic.
Service
drop-down menu.
drop-down menu, select Downstream for inbound traffic.
fields. These are required for both
F
Service
187