Cisco RV016 - Small Business - 10/100 VPN Router Administration Manual page 24

Viewing System Summary Information
NOTE
Cisco Small Business RV0xx Series Routers Administration Guide
- Auto negotiation: The auto negotiation setting, On or Off.
- VLAN: The VLAN ID.
- Receive Packet Count: The number of packets received through this
port.
- Receive Packet Byte Count: The number of bytes received through this
port.
- Transmit Packet Count: The number of packets transmitted through
this port.
- Transmit Packet Byte Count: The number of bytes transmitted through
this port.
- Packet Error Count: The number of packet errors.
WAN Status
This section displays information for the WAN1 interface as well as DMZ or WAN2,
depending on your configuration. On Cisco RV016, additional WAN interfaces may
be configured. Use the tabs to view the IPv4 and IPv6 information.
The IPv6 tab is available if Dual-Stack IP is enabled on the Setup > Network page.
• WAN information:
- IP Address: The current public IP address for this interface.
- Default Gateway: The default gateway for this interface.
- DNS: The IP address of the DNS server for this interface.
- Dynamic DNS (IPv4 only): The DDNS settings for this port, Disabled or
Enabled.
- Release and Renew: These buttons appear if the port is set to obtain an
IP address automatically. Click Release to release the IP address, and
click Renew to update the DHCP lease time or to get a new IP address.
- Connect and Disconnect: These buttons appear if the port is set to
PPPoE or PPTP. Click Disconnect to disconnect from the Internet
service. Click Connect to re-establish the connection.
2
24