Olivetti Fax-Lab 470 Instructions Manual page 43

C
HANGING THE SILENCE LAPSE
This function is only enabled in some countries.
If the TAD has a shorter silence lapse set up as the fax
machine,the latter can never automatically go to Reception,
since the TAD occupies the line first. If no message is
received within the preset time, the connection is
automatically aborted. In this case, the silence lapse on
the fax machine must be shortened so that this occupies
the line first.
To change the preset silence lapse, proceed as follows:
1. Press the key
until the display shows:
2. Press the key
until the display shows:
You can choose the following silence lapses: "3", "4", "6",
"8", "10" and "OFF"
3. To do so, repeatedly press the key:
/
4. To confirm the selection, press the key:
5. To return the fax machine to the stand-by mode, press the
key:
C
HANGING THE FAX MACHINE REMOTE OPERATION CODE
You can enable reception on the fax machine from a remote
telephone. The fax machine must be set up for manual
reception and the remote telephone must use tone dialling.
Type in the code ** for remote fax operation on the remote
telephone. This operation has the same effect as pressing
the key on the fax machine.
You can replace the second asterisk of this code using digits
from 0 to 9.
1. Press the key
until the display shows:
2. Press the key:
The display shows:
3. Press the key:
The display shows the line to which the fax machine was set
to be connected, for example:
4. Press the key
until the display shows:
5. Press the key:
The display shows the code you set previously, for example:
Enter the new code (e.g. "*9").
6. To do so, press the key:
-
7. To confirm the selection, press the key:
8. To return the fax machine to the stand-by mode, press the
key:
Note
To disable this function
1. Press |/} after the fourth step to display "REMOTE START:OFF".
2. To confirm the entry, press the
3. Press the key.
The fax machine returns to the stand-by mode.
Note
If you are connected to a private line, follow the same procedure until
the display shows "PUBL.LINE (PSTN)", press the |/} keys to display:
"PRIV.LINE (PBX)" and then continue as described in the procedure.
key.
37