RangeMax NEXT Wireless-N Access Point WN802T Reference Manual
•
Delivers stable, application enhancing connections using Steady-Stream technology.
•
Wi-Fi Protected Access 2 (WPA2) encryption and authentication
•
RADIUS authentication support
•
Easy, Web-based setup for installation and management.
•
NetBIOS login capability
•
Front panel LEDs for easy monitoring of status and activity.
•
Flash memory for firmware upgrades.
•
Wi-Fi Multimedia (WMM) Quality of Service (QoS) which allows time-dependent
information, such as video or audio, to have a higher priority than normal traffic.To implement
WMM correctly, wireless clients must also support WMM. (Not available in Client Mode.)
•
Operates in three modes for maximum flexibility:
–
Access Point. In this mode, operates as a standard 802.11b/g wireless access point.
–
Wireless Multi-Point Bridging. In this mode, acts as the "master" for a group of bridge-
mode wireless stations.
–
Repeater with Wireless Client Association. In this mode, operates as both a wireless
access point and a wireless bridge.
System Requirements
Before installing the WN802T, make sure your system meets these requirements.
•
A 10/100/1000 Mbps Local Area Network device such as a hub, router, or switch.
•
The Category 5 UTP straight through Ethernet cable with RJ-45 connector included in the
package, or one like it.
•
A 100-240 V, 50-60 HZ AC Switching Power Supply.
•
A Web browser for configuration such as Microsoft Internet Explorer 6.0 or above, Netscape
Navigator 4.78 or above or Mozilla Firefox.
•
At least one computer with the TCP/IP protocol installed.
•
802.11b/g/Next or 802.11b/g -compliant devices.
1-2
.
v1.0, August 2007
Introduction