NETGEAR WN802T - RangeMax Next Wireless Access Point User Manual page 26

RangeMax NEXT Wireless-N Access Point WN802T Reference Manual
.
Figure 2-4
2. From the Country/Region pull-down menu, select the region where the WN802T can be used
(the Country/Region is not Configurable in the United States; but is configurable in the rest of
the world).
Note: If your country or region is not listed, please check with your local government
agency.
3. Configure the Wireless LAN settings based on the following field descriptions:
• Turn Radio On. On by default, you can also turn off the radio to disable access through
this device. This can be helpful for configuration, network tuning, or troubleshooting
activities.
• Wireless Network Name (SSID). Enter a 32-character (maximum) service set ID in this
field; the characters are case sensitive. When the wireless access point is deployed in
"infrastructure" mode, the SSID assigned to a wireless device must match the wireless
access point SSID in order for the wireless device to communicate with the WN802T. If
they do not match, you will not get a wireless connection to the WN802T. The default is
NETGEAR.
• Broadcast Wireless Network Name (SSID). If Enabled, the Wireless Access Point
broadcasts its SSID allowing Wireless Stations which have a "null" (blank) SSID to adopt
the correct SSID. If set to disable, the SSID is not broadcast. The default is Enabled.
• Wireless Mode. From the pull-down menu, select the desired wireless operating mode:
– b/g – Both 802.11b and 802.11g wireless stations can be used.
11
2-8
v1.0, August 2007
Installation and Configuration