Table of Contents
Advertisement
Step 1: Consider the System Requirements
Before installing the access point, make sure that your network includes the following
components:
•
An NBASE-T or 10/100/1000BASE-T PoE+ (802.3at) switch.
Note:
The access point requires PoE+. PoE (802.3af) is not sufficient.
•
If the switch does not provide PoE+, a NETGEAR power adapter for the access point and
an AC power source.
•
A NETGEAR wireless controller in the same Layer 2 or Layer 3 network as the access
point.
•
If the network does not include a DHCP server, a computer with a static IP address of
192.168.0.210 and a subnet mask of 255.255.255.0 so that you can connect to the
access point at its default IP address of 192.168.0.160 and configure the appropriate IP
address for your network.
Step 2: Consider the WiFi Equipment Placement and Range
Guidelines
The range of your WiFi connection can vary significantly based on the location of the access
point. The latency, data throughput performance, and power consumption of WiFi devices
also vary depending on your configuration choices. In addition, the time it takes to establish a
WiFi connection can vary depending on both your security settings and placement.
Note:
Failure to follow these guidelines can result in significant performance
degradation or inability to connect over WiFi to the access point. For
complete performance specifications, see
Information.
For best results, place your access point according to the following general guidelines:
•
Near the center of the area in which the WiFi devices will operate.
•
In an elevated location such as a high shelf where the WiFi devices are in within a line of
sight (even if through walls).
•
Away from possible sources of interference such as the following:
-
Ceiling fans
-
Home security systems
-
Microwaves
-
Computers
-
Base of a cordless phone
ProSAFE Dual Band Wireless AC Access Point Model WAC740
Installation
Appendix B, Supplemental
15
Advertisement
Table of Contents
Troubleshooting
