NETGEAR WN802T - RangeMax Next Wireless Access Point User Manual page 24

RangeMax NEXT Wireless-N Access Point WN802T Reference Manual
Figure 2-3
2. Enter the Access Point Name of the WN802T.
This unique name is the access point NetBIOS name. The Access Point Name is printed on the
rear label of the WN802T. The default is netgearxxxxxx, where xxxxxxx represents the last 6
digits of the WN802T MAC address. You may modify the default name with a unique name
up to 15 characters long.
3. Enter the IP Address fields of the WN802T.
– DHCP Client. By default, the Dynamic Host Configuration Protocol (DHCP) client is
disabled. If you have a DHCP server on your LAN and you enable DHCP, the wireless
access point will get its IP address, subnet mask and default gateway settings
automatically from the DHCP server on your network when you connect the WN802T to
your LAN.
– IP Address. Enter the IP Address of your wireless access point.The default IP address is
192.168.0.233. To change it, enter an unused IP address from the address range used on
your LAN; or enable DHCP.
– IP Subnet Mask. The Access Point will automatically calculate the subnet mask based on
the IP address that you assign. Otherwise, you can use 255.255.255.0 (the default) as the
subnet mask.
2-6
v1.0, August 2007
Installation and Configuration