Table of Contents
Advertisement
Additionally, the ME102 Wireless Access Point supports the following wireless features:
Distributed coordinated function (CSMA/CA, Back off procedure, ACK procedure, retransmission of
unacknowledged frames
RTS/CTS handshake
Duplicate detection and Recovery
Beacon generation
Fragmentation and reassembly
Authentication Algorithm (Open System, Shared Key)
Short or long preamble
Roaming among access points on the same subnet
LED Indicators
The ME102 802.11b Wireless Access Point provides three status LEDs: Power(Yellow), Ethernet
Link/Activity(Green) and Wireless Link/Activity(Yellow).
LED
Off
Power
On
Off
Green On
Ethernet
(Link/Activity)
Green Blink
Off
Wireless
Fast Blink
(Link/Activity)
System Requirements
Before installing the ME102, make sure of you meet the following requirements:
A 10 Mbps port of a Local Area Network device such as hub or switch
♦
♦
A Category 3 or 5 UTP Ethernet cable with RJ-45 connector
An A/C Power outlet (100-240 V, 50-60 HZ)
♦
One computer with USB support and Ethernet connection
♦
Windows 98, Millennium, 2000, or XP
♦
Status
No Power
Power On
Indicates no Ethernet link detected
10 Mbps Ethernet link detected but no
activity
Indicates data traffic on the 100 Mbps
LAN
Indicates no wireless link
Indicates the ME102 is transmitting or
receiving data through wireless links
Description
6
Advertisement
Table of Contents
