Default Settings and Technical Specifications
This appendix provides the factory default settings and technical specifications for the RangeMax
NEXT Wireless-N Access Point.
Factory Default Settings
You can use the reset button located on the front of your device to reset all settings to their factory
defaults. This is called a hard reset.
•
To perform a hard reset, push and hold the reset button for approximately 5 seconds (until the
Power LED changes from blinking green to solid amber). Your device will return to the
factory configuration settings shown in
•
Pressing the reset button for a shorter period of time will simply cause your device to reboot.
Table A-1. Access Point Default Configuration Settings
Feature
AP Login
User Login URL
User Name (case sensitive)
Login Password (case sensitive)
Ethernet Connection
Access Point Name
Ethernet MAC Address
Access Point Mode
Port Speed
Local Network (LAN)
Default Settings and Technical Specifications
Table A-1
below.
Description
192.168.0.233 or
netgearxxxxxx"; where xxxxxx is the last 6 hexadecimal
digits of the WN802T MAC address
admin
password
netgearxxxxxx where xxxxxx are the last 6 digits of the
wireless access point MAC address.
See rear label.
On
10/100/1000 Mbps
v1.0, August 2007
Appendix A
.
A-1