Igmp Filters Configuration - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Interface Manual

The following table describes the IGMP Snooping Configuration controls:
Table 141 IGMP Snooping Configuration controls
Control
IGMP on?
Set report timeout
Set multicast router timeout
Set robust value or expected
packet loss on subnet
Set query interval
Aggregate IGMP report
Set Source IP for GSQ proxy
Remove all VLANs from IGMP
Snooping
Configured VLANs
Snooping VLANs
Snooping VLANs without Fstleave
Snooping VLANs with Fstleave

IGMP Filters Configuration

To display the following form, select Layer 3 > IGMP > IGMP Filters (click the underlined text, not the folder).
This form summarizes IGMP filter parameters. Use IGMP filters to allow or deny a port to send and receive
multicast traffic.
Descriptions
Enables or disables IGMP Snooping.
Configures the timeout value for IGMP Membership Reports (host). Once the timeout value
is reached, the switch removes the host from its IGMP table, if the conditions are met. The
range is from 1 to 255 seconds. The default is 10 seconds.
Configures the timeout value for IGMP Membership Queries (Mrouter). Once the timeout
value is reached, the switch removes the multicast router from its IGMP table, if the proper
conditions are met. The range is from 1 to 255 seconds. The default is 255 seconds.
Configures the IGMP Robustness variable, which allows you to tune the switch for
expected packet loss on the subnet. If the subnet is expected to be lossy (high rate of
packet loss), increase the value. The range is from 2 to 10. The default value is 2.
Sets the IGMP router query interval, in seconds. The default value is 125.
Enables or disables IGMP Membership Report aggregation.
Configures the source IP address used as a proxy for IGMP Group Specific Queries.
Removes all VLANs from the list of Snooping VLANs.
Lists the VLANs that can be assigned for IGMP Snooping.
Enables or disables IGMP Snooping on selected VLANs.
Add: Adds selected VLANs to the Snooping VLANs list. To add a VLAN, select the VLAN
in the Configured VLANs list, and click Add
Remove: Removes selected VLANs from the Snooping VLANs list.
Lists the Snooping VLANs that can be assigned for Fstleave processing.
Enables or disables FastLeave processing. FastLeave allows the switch to immediately
remove a port from the IGMP port list, if the host sends a Leave message, and the proper
conditions are met. This command is disabled by default.
Add: Adds selected VLANs to the Snooping VLANs with Fstleave list. To add a VLAN,
select the VLAN in the Snooping VLANs without Fstleave list, and click Add
Remove: Removes selected VLANs from the Snooping VLANs with Fstleave list.
.
.
Configuring the switch 173