802.1X Port Configuration - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Interface Manual

802.1x Port Configuration

To display the following form, go to the Switch Ports 802.1x Configuration form. Select a port number.
The following table describes the Port 802.1x Configuration controls:
Table 106 Port 802.1x Configuration controls
Control
Auth Mode
Quiet Period (0-65535 sec)
Tx Period (0-65535 sec)
Max Req (1-10)
Supplicant Timeout (0-65535 sec)
Server Timeout (0-65535 sec)
ReAuth Status
ReAuth Period (1-604800 sec)
Description
Sets the type of access control for all ports:
- the port is unauthorized unconditionally.
force-unauth
- the port is unauthorized until it is successfully authorized by the
auto
RADIUS server.
- the port is authorized unconditionally, allowing all traffic.
force-auth
The default value is force-auth.
Sets the time, in seconds, the authenticator waits before transmitting an EAP-
Request/ Identity frame to the supplicant (client) after an authentication failure in the
previous round of authentication. The default value is 60 seconds.
Sets the time, in seconds, the authenticator waits for an EAP-Response/Identity
frame from the supplicant (client) before retransmitting an EAP-Request/Identity
frame. The default value is 30 seconds.
Sets the maximum number of times the authenticator retransmits an EAP-Request
packet to the supplicant (client). The default value is 2.
Sets the time, in seconds, the authenticator waits for an EAP-Response packet from
the supplicant (client) before retransmitting the EAP-Request packet to the
authentication server. The default value is 30 seconds.
Sets the time, in seconds, the authenticator waits for a response from the Radius
server before declaring an authentication timeout. The default value is 30 seconds.
The time interval between transmissions of the RADIUS Access-Request packet
containing the supplicant's (client's) EAP-Response packet is determined by the
current setting of
/cfg/sys/radius/timeout
Sets the re-authentication status to
Sets the time, in seconds, the authenticator waits before re-authenticating a
supplicant (client) when periodic re-authentication is enabled. The default value is
3600 seconds.
(default is 3 seconds).
or . The default value is
on off
Configuring the switch 137
.
off