HP GbE2c - Blc Layer 2/3 Fiber SFP Option Interface Manual page 132

Table 101 Switch Port Configuration controls
Control
PVID Tagging
Port STP
Default Port VLAN ID (1-4095)
Flow Control
Autonegotiation
Speed
Duplex mode
Enable/Disable sending Link UP/Down Trap
Port Name
Multicast Threshold
Multicast Threshold Rate (0-262143)
Broadcast Threshold
Broadcast Threshold Rate (0-262143)
Destination Look Up Fail Threshold
Destination Lookup Fail Threshold Rate (0-
262143)
802.1p Port Priority (0-7)
Description
Disables or enables VLAN tag persistence. When disabled, the VLAN tag
is removed from packets whose VLAN tag matches the port PVID. The
default value is enabled.
Turns Spanning Tree On or Off for this port.
Sets the default VLAN number which will be used to forward frames
which are not VLAN tagged.
The default number is 1.
Note: VLAN 4095 is reserved for switch management.
Sets the flow control. The choices include:
Receive flow control
Transmit flow control
Both receive and transmit flow control (default)
No flow control
Enables or disables auto negotiation for the port.
Sets the link speed. Not all options are valid on all ports. The choices
include:
"Any," for automatic detection (default)
10 Mbps
100 Mbps
1000 Mbps
Sets the operating mode. Not all options are valid on all ports. The
choices include:
"Any," for auto negotiation (default)
Full-duplex
Half-duplex
Enables or disables the sending of SNMP link up and link down traps.
The default setting is enabled.
Sets a name for the port. The assigned port name appears next to the
port number on some information and statistics screens.
Enables or disables multicast threshold limit.
Limits the number of multicast packets to the specified value. If disabled
( ), the port forwards all multicast packets.
dis
Configures the threshold rate for multicast packets, in packets per second.
Enables or disables broadcast threshold limit.
Limits the number of broadcast packets to the specified value. If disabled
( ), the port forwards all broadcast packets.
dis
Configures the threshold rate for broadcast packets, in packets per
second.
Enables or disables threshold limit for destination lookup failures.
Limits the number of unknown unicast packets to the specified value. If
disabled ( ), the port forwards all unknown unicast packets.
dis
Configures the threshold rate for destination lookup failures, in packets
per second.
Configures the port's 802.1p priority level.
Configuring the switch 132