Switch Management Processor Configuration Buttons - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Interface Manual

The following table describes the Switch Management Processor Configuration (SNMP) controls:
Table 91 Switch Management Processor Configuration (SNMP) controls
Control
SNMP System Name
SNMP Location
SNMP Contact
SNMP Read Community String
SNMP Write Community String
SNMP state machine timeout (1-30 minutes)
Send SNMP Auth. Failure Traps?

Switch Management Processor Configuration buttons

The following table describes the Switch Management Processor Configuration buttons:
Table 92 Switch Management Processor Configuration buttons
Control
Submit
Diff
Diff Flash
Revert
Revert Apply
Description
Configures the name for the system. The name can have a maximum of 32
characters.
Configures the name of the system location. The location can have a
maximum of 32 characters.
Configures the name of the system contact. The contact can have a
maximum of 32 characters.
Configures the SNMP read community string. The read community string
controls SNMP "get" access to the switch. It can have a maximum of 32
characters. The default read community string is public.
Configures the SNMP write community string. The write community string
controls SNMP "set" and "get" access to the switch. It can have a
maximum of 32 characters. The default write community string is private.
Sets the timeout value for the SNMP state machine.
Enables or disables the use of the system authentication trap facility. The
default setting is disabled.
Description
Sends this form to the switch. Any configuration changes are placed in the "pending" state
and do not take effect until the toolbar Apply command is given.
Shows any pending configuration changes.
Compares new configuration with the flash configuration.
Removes pending configuration changes between apply commands. Use this command to
restore configuration parameters set since last apply command.
Removes pending configuration changes between save commands. Use this command to
restore configuration parameters set since last save command.
Configuring the switch 117