802.1X Port Configuration - HP 445860-B21 - 10Gb Ethernet BL-c Switch Reference Manual

802.1x Port Configuration

To display the following form, go to the Switch Ports 802.1x Configuration form. Select a port number.
The following table describes the Port 802.1x Configuration controls:
Port 802.1x Configuration controls
Table 113
Control
Auth Mode
Quiet Period (0-65535 sec)
Tx Period (0-65535 sec)
Max Req (1-10)
Supplicant Timeout (0-65535 sec)
Description
Sets the type of access control for all ports:
force-unauth—the port is unauthorized unconditionally.
auto—the port is unauthorized until it is successfully authorized by the
RADIUS server.
force-auth—the port is authorized unconditionally, allowing all traffic.
The default value is force-auth.
Sets the time, in seconds, the authenticator waits before transmitting an EAP-
Request/ Identity frame to the supplicant (client) after an authentication failure
in the previous round of authentication. The default value is 60 seconds.
Sets the time, in seconds, the authenticator waits for an EAP-Response/Identity
frame from the supplicant (client) before retransmitting an EAP-Request/Identity
frame. The default value is 30 seconds.
Sets the maximum number of times the authenticator retransmits an EAP-
Request packet to the supplicant (client). The default value is 2.
Sets the time, in seconds, the authenticator waits for an EAP-Response packet
from the supplicant (client) before retransmitting the EAP-Request packet from
the authentication server. The default value is 30 seconds.
Configuring the switch
174