Table 1-2: Access Unit Odu Types; Additional Installation Requirements - Alvarion BreezeACCESS VL System Manual

AU ODU Type
AU-E-ODU (all bands
except 0.9 GHz)
New AU-E-ODU
(0.9 GHz units only)
Pole mounting kit for the AU-ODU (the kit for the new, smaller-size ODU is
different from the kit for all other ODUs)
RF cable
2.1.1.4 Optional Items Available from Alvarion
IDU to ODU Category 5 Ethernet cable with a shielded RJ-45 connector
crimped on one end and two shielded RJ-45 connectors (available in different
lengths. For more details refer to section 2.1.2)
Tilt Pole Mounting kit for the new, smaller size ODU.
A Y-cable for connecting directly to the IDU COM of ODUs with a new (smaller
size) enclosure for configuration/performance monitoring using a portable PC.
2.1.1.5

Additional Installation Requirements

The following items are also required to install the BreezeACCESS VL system
components:
Ethernet cable (straight for connecting to a hub/switch etc., crossed for
connecting directly to a PC's NIC)
Crimping tool for RJ-45 connectors
Antenna, for E model units supplied without an antenna
Ground cables with an appropriate termination
Installation
Table 2-3: Access Unit ODU Types
A rectangular enclosure (30.5 x 11.7 x 5.7 cm) with a connection
to an external antenna (not included). Not available in the 0.9
GHz band. HW revision D or lower.
A diamond shaped enclosure (22 x 22 x 7 cm) with a connection
to an external antenna (not included). The smaller size new AU-E-
ODU (HW revision F) is currently available only in the 0.9 GHz
band.
Installation Requirements
Description
37