Figure 2-18: Window Mounting With Rotation Capability - Alvarion BreezeACCESS VL System Manual

Chapter 2 - Installation
2.5.5.4 Window Mount with Rotation Capability
The installation kit includes the following: 4 PHK40*16PT screws (1), 2 M4
washers (2), 2 rotation bars (3) and 2 suction cups (4).
Attach the rotation bars to the antenna and the suction cups to the rotation
1
bars. Refer to Figure 2-18 for directions.
Determine the location of the antenna on the glass. Attach it to the window by
2
pressing the suction cups onto the glass.
Connect the antenna cable to the connector located on the bottom side of the
3
antenna. Use only the torque key supplied with the antenna. Do not over
tighten. Do not use a wrench or a similar tightening tool.
Rotate the antenna left or right so the domed surface of the antenna is facing
4
the direction of the Base Station. Check the received Signal LEDs to ensure
the antenna is aimed correctly.
CAUTION
The suction cups are sensitive to weather conditions and may not hold in high temperatures or
during rain. It is strongly recommended to mount the antenna on the wall using the supplied
brackets.

Figure 2-18: Window Mounting with Rotation Capability

62
BreezeACCESS VL System Manual