Alvarion BreezeACCESS VL System Manual page 197

4.2.6.3.7 SNMP Traps (AU Only)
The SNMP submenu enables or disables the transmission of SNMP Traps. If this
option is enabled, up to 10 IP addresses of stations to which SNMP traps are sent
can be defined.
Starting on SW Version 5.0, traps are generated and sent only by the AU: relevant
events in an SU are reported by the SU to the serving AU that generates the
applicable trap on behalf of the SU.
For more details on the system traps see the relevant Traps document.
4.2.6.3.7.1 Send SNMP Traps
The Send SNMP Traps option enables or disables the sending of SNMP traps.
The default selection is Disable.
4.2.6.3.7.2 SNMP Traps Destination IP Addresses
The SNMP Traps Destination IP Addresses submenu enables defining up to 10 IP
addresses of devices to which the SNMP Traps are to be sent.
The default of all 10 SNMP Traps IP destinations is 0.0.0.0.
4.2.6.3.7.3 SNMP Traps Community
The SNMP Traps Community option enables defining the Community name for
each IP address to which SNMP Trap messages are to be sent.
Valid strings: Up to 8 ASCII characters.
The default for all 10 addresses is "public", which is the default Read community.
4.2.6.3.7.4 Delete One Trap Address
The Delete One Trap Address option enables deleting Trap address entries from
the SNMP Traps Addresses list.
4.2.6.3.7.5 Delete All Trap Addresses
The Delete All Trap Addresses option enables deleting all entries from the SNMP
Traps Addresses list.
4.2.6.3.8 Wi2 IP Address (SU Only)
The BreezeACCESS WI
advanced WiFi Access Point and a BreezeACCESS SU-ODU that provides
backhaul connectivity. The Wi2 IP Address parameter enables the installer to
configure in the SU the IP address of the WiFi AP connected to it, providing
availability of the IP address information for remote management of the AP.
The default Wi2 IP Address is 0.0.0.0 (meaning none).
Operation and Administration
system comprises a self-contained combination of an
2
Menus and Parameters
165