Connecting The Indoor-To-Outdoor Cable; Figure 2-7: Bottom Panel Of The Outdoor Unit (Excluding B10 Odu), Shown Without The Seal As; Figure 2-8: Bottom Panel Of The Bu/Rb-B10 Odu (Without Idu Com Sealing Cap) - Alvarion BreezeNET B System Manual

Chapter 2 - Installation
Figure 2-7: Bottom Panel of the Outdoor Unit (excluding B10 ODU), shown without the seal

Figure 2-8: Bottom Panel of the BU/RB-B10 ODU (without IDU COM Sealing Cap)

NOTE
The MAC Address of the unit is marked on both the ODU and the IDU (on the bottom side of the
unit). If for any reason the ODU is not used with the IDU with which it was shipped, the MAC
Address of the system is in accordance with the marking on the ODU.
2.3.5

Connecting the Indoor-to-Outdoor Cable

2.3.5.1 Units with an Installed Waterproof Seal (not applicable for
BU/RB-B10)
To connect the indoor-to-outdoor cable:
Remove the two screws holding the waterproof seal to the outdoor unit and
1
remove the waterproof seal.
BreezeNET B
assembly)
28
Installing the Outdoor Unit
System Manual