Wall Mount - Alvarion BreezeACCESS VL System Manual

Chapter 2 - Installation
NOTE
Ensure that the antenna is mounted vertical to the floor, with the connector facing downward, and
the front of the antenna facing to the exterior of the building, preferably directed towards the Base
Station.
CAUTION
In order to avoid damage from lightning strikes, the antenna must be placed below roof level.
2.5.5.1

Wall Mount

The installation kit includes 2 plastic anchors and 2 #8 screws.
If anchors are needed (wall-board, plaster board, etc.), drill two holes for the
1
anchors using a 5 mm drill bit and insert anchors. Use a 9/64" drill bit for
screwing directly into a solid surface (stud).
Fasten the antenna to the wall. Refer to Figure 2-15 for directions. Use the
2
two #8 screws provided with the kit. Do not over tighten.
Connect the antenna cable to the connector located on the bottom side of the
3
antenna. Hand tighten, do not use a wrench or a similar tightening tool. Do
not over tighten.
58
BreezeACCESS VL System Manual