Alvarion BreezeACCESS VL System Manual page 100

Chapter 2 - Installation
OVERTEMP alarm indicator is off. Refer to Table 2-6 for a description of these
LEDs.
Configure the basic parameters in all BS-AU modules as described in section
11
3.1.
Connect the 10/100 BaseT LAN connector(s) to the network. The cable
12
connection should be straight Ethernet if connecting the indoor unit to a
hub/switch and a crossed cable if connecting it directly to a PC Network
Interface Card (NIC).
NOTE
The length of each of the Ethernet cables (the cable connecting the indoor unit to the user's
equipment and the Indoor-to-Outdoor cable) should not exceed 100 meters.
Reset the unit using the RESET button after connecting or reconnecting the indoor and outdoor
units with the indoor-to-outdoor cable.
68
BreezeACCESS VL System Manual