Record Bios Setup Settings; If Bios Setup Is Inaccessible; Bios Setup Menus; Bios Setup Menu Navigation - Intel SCB2 - Server Board Motherboard Product Manual

Run the System Setup Utility (SSU) to setup the following:
Enable Server Management Features
Read System Event Log (SEL)
Read Sensor Data Records
Read System FRU Information
Specify boot device sequence
Setup system passwords

Record BIOS Setup Settings

Record your BIOS Setup settings. If default values ever need restoring (after a CMOS clear, for
example), you must run BIOS Setup again. Your record will make this much easier.

If BIOS Setup Is Inaccessible

If you have a misconfigured diskette drive, and you cannot use BIOS Setup to correct the problem,
you might need to clear CMOS memory. To clear CMOS, either of two methods can be used.
1. Press the reset button and hold it down for four seconds or more, and then, while holding the
reset button down, press the power button. Release both buttons at the same time.
2. Move the "Clear CMOS" jumper found on the configuration jumper block on the baseboard.

BIOS Setup Menus

Table 7.

BIOS Setup Menu Navigation

To:
Get general help
Move between menus
Go to the previous item
Go to the next Item
Change the value of an item
Select an item or display a submenu
Leave a submenu or exit BIOS Setup
Reset to BIOS Setup defaults
Save and exit BIOS Setup
44
Press:
<F1> or <Alt+H>
+ or -
<Enter>
<Esc>
<F9>
<F10>
Intel Server Board SCB2 Product Guide