Job Prints From The Wrong Tray Or On The Wrong Paper; Incorrect Characters Print; Tray Linking Does Not Work - Lexmark T656 User Manual

Troubleshooting
C
HANGE ENVIRONMENTAL SETTINGS
When using Eco‑Mode or Quiet Mode settings, you may notice a short delay before the first page is printed. If you
want to change the settings and need more information, then see "Using Eco‑Mode" on page 63 or "Reducing printer
noise" on page 66.

Job prints from the wrong tray or on the wrong paper

C
HECK THE PAPER TYPE SETTING
Make sure the paper type setting matches the paper loaded in the tray:
1
From the printer control panel, check the Paper Type setting from the Paper menu.
2
Before sending the job to print, specify the correct type setting:
•
For Windows users, specify the type from Print Properties.
• For Macintosh users, specify the type from the Print dialog.

Incorrect characters print

M
AKE SURE THE PRINTER IS NOT IN
If Ready Hex appears on the display, then you must exit Hex Trace mode before you can print your job. Turn the
printer off and back on to exit Hex Trace mode.

Tray linking does not work

These are possible solutions. Try one or more of the following:
L
OAD THE SAME SIZE AND TYPE OF PAPER
•
Load the same size and type of paper in each tray to be linked.
•
Move the paper guides to the correct positions for the paper size loaded in each tray.
U P
SE THE SAME APER
•
Print a menu settings page and compare the settings for each tray.
•
If necessary, adjust the settings from the Paper Size/Type menu.
Note: The multipurpose feeder does not automatically sense the paper size. You must set the size from the Paper
Size/Type menu.
H T
EX RACE MODE
S P T
IZE AND APER YPE SETTINGS
173