4 Replacement Procedures
4.17 Sound board/MIC harness
Removing the Sound board/MIC harness
To remove the sound board/MIC harness, follow the steps below and refer to Figure 4-22 and
Figure 4-23.
1. Remove the following screw securing the sound board.
• M2×4C
2. Disconnect the sound board FPC and speaker harness from the connector CN9510
and CN6350 on the sound board and remove the sound board from the slot.
Speaker harness
Figure 4-22 Removing the sound board/MIC harness (1)
4-42
[CONFIDENTIAL]
×1
BIND
Sound board
CN6350
Sound board FPC
4.17 Sound board/MIC harness
M2x4C BIND
CN9510
PORTÉGÉ A600 Maintenance Manual (960-710)