Toshiba Portege A600 Maintenance Manual page 276

4 Replacement Procedures
2. Open the insulator and take out the RJ45 wire harness from the slot.
3. Disconnect the USB board FPC from the connector CN9610 on the USB board.
4. Open the insulator and disconnect the sensor harness from the connector CN9540
on the USB board and connector CN9630 on the SW board.
5. Disconnect the camera harness from the connector CN9620 on the USB board.
6. Remove the following screw and USB board.
• M2×3B
Insulator
CN9620
Insulator
Figure 4-27 Removing the USB board/WL SW holder (2)
4-48 [CONFIDENTIAL]
S-THIN HEAD
Sensor harness
Camera harness
CN9630
4.20 USB board/WL SW holder
×1
M2x3B S-THIN HEAD
USB board
Knob
Slot
USB board FPC
PORTÉGÉ A600 Maintenance Manual (960-710)
CN9610
CN9540
RJ45 wire harness