Toshiba Portege A600 Maintenance Manual page 271

4.17 Sound board/MIC harness
3. Disconnect the MIC harness from the connector CN6050 on the sound board and
remove the MIC harness from the sound board.
Figure 4-23 Removing the sound board/MIC harness (2)
Installing the Sound board/MIC harness
To install the sound board/MIC harness, follow the steps below and refer to Figure 4-22 and
4-23.
1. Set the MIC harness to the slot of the sound board and connect the MIC harness to
the connector CN6050 on the sound board.
2. Connect the sound board FPC and speaker harness to the connector CN9510 and
CN6350 on the sound board.
3. Set the sound board to the slot and secure it with following screw.
• M2×4C
PORTÉGÉ A600 Maintenance Manual (960-710)
×1
BIND
4 Replacement Procedures
CN6050
[CONFIDENTIAL]
MIC harness
4-43