Epson WorkForce AL-M200DN User Manual page 85

5. Select the desired access point, and then press the
If the desired access point does not appear:
a Select Manual Setup, and then press the
b Enter the SSID, and then press the
Use the
cursor.
c Select Infrastructure, and then press the
d Select an encryption type, and then press the
Important:
Be sure to use one of the supported encryption methods to protect your network traffic.
6. Enter the WEP key or pass phrase, and then press the
Use the or
When the encryption type is WEP, select a transmit key after entering the WEP key.
7. Wait a few minutes until the printer restarts to establish the wireless network.
8. Print a System Settings page from the operator panel.
See "Printing and Checking the System Settings Page" on page 34.
9. Confirm that "Link Quality" is shown as "Good", "Acceptable" or "Low" on the report.
Note:
When "Link Quality" is "No Reception", check if the wireless settings are correctly configured.
Using Ad Hoc Connection
To configure the wireless settings for an ad-hoc connection where the wireless devices communicate
directly with each other without an access point:
1. On the operator panel, press the
or button to enter the desired value, and press the
button to enter the desired value, and press the
(Menu) button.
button.
button.
button.
button.
button.
button.
or
Printer Connection and Software Installation
AL-M200 Series User's Guide
or button to move a
button to move a cursor.
85