Epson WorkForce AL-M200DN User Manual page 40

c If you want to set a printer as the default for printing, select the Set this printer as default
for printing check box.
7. Select the software and documentation you want to install, and then click Install. You can specify
folders in which to install the software and documentation. To change the folders, click
Browse.
8. Click Finish to exit the wizard.
Configuring Wireless Network Settings (AL-M200DW only)
You can configure wireless network settings with Easy Install Navi.
Important:
❏ Be sure to obtain the SSID and security information from a system administrator in advance when
you use a communications standard other than WPS to configure wireless network settings.
❏ Ensure that the Ethernet cable has been disconnected from the printer before you configure the
wireless network settings.
The wireless network specifications are described below:
Item
Connectivity
Connectivity Standard
Bandwidth
Data Transfer Rate
Security
Certifications
Wi-Fi Protected Setup (WPS)
You can select a method to configure wireless network settings from the following:
Wizard Setup Through USB Connection
Specification
Wireless
IEEE 802.11b/g compliant
2.4 GHz
IEEE 802.11b mode: 11, 5.5, 2, 1 Mbps
IEEE 802.11g mode: 54, 48, 36, 24, 18, 12, 9, 6 Mbps
64 (40-bit key)/ 128 (104- bit key) WEP, WPA- PSK (TKIP, AES), WPA2-PSK (AES)
(IEEE802.1x attestation function of WPA 1x non-corresponds)
Wi-Fi, WPA2.0 (Personal)
Push Button Configuration (PBC), Personal Identification Number (PIN)
Printer Connection and Software Installation
AL-M200 Series User's Guide
40