Automatic Sewing; If The Belt Loops Run Out During Automatic Sewing - Brother BAS-705 Instruction Manual

4. SEWING

4-7. Automatic sewing

AUTO MODE
1st bobbin counter
2nd bobbin counter
Production counter
MODE
q

4-7-1. If the belt loops run out during automatic sewing

No loop
Pass loop through the channel
1. Press the MODE switch q to select AUTO mode.
2. If no belt loop has been set, press the LOOP switch
3. Set the material.
4. Press the START switch e to start sewing in AUTO
w
<Correcting the production counter>
e
POWER
RESET
r
* A message will appear on the screen.
1. Add more belt loops. The message will disappear
q
2. Press the LOOP switch q.
32
w to set a belt loop.
mode.
While the production counter setting is being
displayed, press the
the counter setting by 1, and press the
decrease the setting by 1.
[If the bobbin thread counters are at "0"]
* If DIP switch No. 2-8 is set to OFF
The previously-set value can be changed. Press the
MODE switch q to return to AUTO mode.
* If DIP switch No. 2-8 is set to ON
The bobbin can be replaced straight away. Moreover,
the previously-set value cannot be changed.
Press the RESET switch r to return to AUTO mode.
from the screen.
The end of the belt loop will be automatically cut and
discarded, and the belt loop material will be set.
SELECT switch to increase
switch to
BAS-705