Threading The Upper Thread - Brother BAS-705 Instruction Manual

4-2. Threading the upper thread

Turn off the power switch before threading the thread, otherwise the machine may operate if the
start switch is depressed by mistake and serious injury could result.
[NOTE]
Turn the machine pulley and raise the thread take-up lever q before threading the upper thread. This will
make threading easier and it will prevent the thread from coming out at the sewing start.
Thread the left-side thread first.
When threading the thread through the needle, allow a distance of approximately 45 mm between the needle
hole and the end of the thread. If the trailing length of the thread is too long, it may cause the thread to
become tangled.
If the thread coming from the thread block catches loosely on the cotton stand, pass the thread through the
thread guide spring when sewing.
[NOTE]
Pass the thtead through the needle eyes from inside to outside.
Pull out about 45mm of thead through each of the needle eyes.
CAUTION
q
[NOTE]
Pass the thread correctly between the tension discs.
25
4. SEWING
BAS-705