Using The Sewing Machine (Sewing Operation); Automatic Sewing (Automatic Sewing Mode) - Brother HE-800C Instruction Manual

6. USING THE SEWING MACHINE (SEWING OPERATION)

Turn off the power switch at the following times, otherwise the machine may operate if the treadle is depressed by
mistake, which could result in injury.
▪ When replacing the bobbin and needle
▪ When not using the machine and when leaving the machine unattended
Use threading mode or turn off the power first in order to carry out threading.
Do not touch any of the moving parts or press any objects against the machine while sewing, as this may result in
personal injury or damage to the machine.
When holding the material, place your right hand at the back and your left hand at the front.
If your left hand is toward the back, it may get caught in the feed arm when it operates or it might touch the moving
parts of the needle trimmer and injury may result.
NOTE:
 The feed arm (1) can move, so be careful of the clearance.
 When using the machine, check that the oil is visible through
the oil cap. If it cannot be seen, stop the machine and eliminate
the cause of the problem.

6-1. Automatic sewing (Automatic sewing mode)


When carrying out automatic sewing for the first time, be sure to carry out a test sewing first.

In addition, if using the sewing machine when the ambient temperature is cold, carry out several test sewing operations to
allow the motor to warm up.
1
Switch the mode to automatic sewing mode.
4222B
2
Select the desired program number (2).
4787M
6. USING THE SEWING MACHINE (SEWING OPERATION)
CAUTION
Information such as the sewing pattern (1), the program number (2),
the cutter operation (3) and the lower thread counter (4) will appear in
the display.
Independent program
(Refer to P. 33)
The program number (2) changes in the order shown in the
illustration each time the
(The key changes the order in the opposite direction.)
HE-800C
Cycle program
(Refer to P. 53)
key is pressed.
4893M
4816M
4817M
48