Data Setting Methods; Setting The Belt Loop Feeding-Out Length - Brother BAS-705 Instruction Manual

3-2.Data setting methods

PROGRAM mode

3-2-1.Setting the belt loop feeding-out length

This sets the length of belt loop material to be fed out before it is cut.
The length can be set to between 50 - 120 mm.
w
PROGRAM MODE
2nd bobbin counter
Speed
Loop length
PROGRAM MODE
2nd bobbin counter
Speed
Loop length
PROGRAM MODE
2nd bobbin counter
Speed
Loop length
PROGRAM MODE
2nd bobbin counter
Speed
Loop length
MODE SELECT
e
z//
zzb
WARNING
CANCEL
ENTER
t
1. Press the MODE switch w to select PROGRAM
mode.
SELECT switches e to move the
2. Use the and
pointer " " so that "Loop length" is selected.
3. While using the SELECT switch eto move the
cursor "-", press the
to set the desired belt loop length.
* If the CANCEL switch r is pressed, the setting
will remain at the previous length setting.
4. Press the ENTER switch t to accept the new length
setting. The cursor "-" will then disappear.
13
3. PANEL OPERATION
POWER
RESET
r
SELECT switches e
and
BAS-705