Mechanisms - Brother BAS-705 Instruction Manual

10-2. Mechanisms

Problem
Belt loops are curved
over front of loop
presser F.
Belt loops are lifted up
when coming out from
cutter.
Belt loops are fed
underneath loop presser
B.
Belt loops are fed
underneath loop presser
F.
Cause
Loop presser F is too
low.
Belt loops are lifted up
when fed out.
Belt loops are too curled.
Loop support T is too
high.
Belt loops are too curled.
Loop support T is too
low.
Loop presser B is too
high.
Belt loops are too curled.
Loop presser F is too
high.
Widths of loop pressers
F and B are too narrow.
Belt loops are too curled.
Check
Relative heights of loop
presser B and loop
presser F
Upper guide plates are
not installed.
Belt loop curl
Distance between loop
support T and the belt
loops
Belt loop curl
Distance between loop
support T and the belt
loops
Distance between cutter
outlet and loop presser
B
Belt loop curl
Relative heights of loop
presser B and loop
presser F
Width of loop pressers
being used
Belt loop curl
79
10. TROUBLESHOOTING
Remedy
Adjust the height of the
loop presser F slider
bracket.
Install the upper guide
plates.
Replace with belt loops
which are not so curled.
Adjust loop support T.
Replace with belt loops
which are not so curled.
Adjust loop support T.
Adjust the height of the
loop presser B slider
bracket.
Replace with belt loops
which are not so curled.
Adjust the height of the
loop presser F slider
bracket.
Replace the lop pressers
with wider ones.
Replace with belt loops
which are not so curled.
Page
50
51
55
55
50
50
51
BAS-705