Initializing The Sewing Data - Brother BAS-705 Instruction Manual

2-13.

Initializing the sewing data

Sewing data such as the bobbin thread counter and production counter settings are stored in a
memory which has a battery backup.
If the power is not turned on for a long period of time (approximately three weeks or more), the
contents of the battery backup memory may become corrupted, causing the error code "E-160" to
appear on the display when the machine is turned on.
If this happens, initialize the sewing data by following the procedure below.
Initialized
Check sewing data
Sewing patterns
Xscale Yscale
Production counter
1st bobbin counter
2nd bobbin counter
Speed
Loop length
main circuit board
129 needle
100% for all sewing
patterns
0
300
300
2100 spm
100
1. Turn off the power switch.
2. Open the control box cover and set DIP switch No. 4
on the main circuit board to ON.
(Refer to "8-2. Main circuit board DIP switch funtions"
on page 68.)
3. Turn on the power. After approximately 2 seconds
have passed, "Initialized" will appear on the display.
4. Turn off the power switch, set DIP switch No. 4 on
the main circuit board to "OFF", and then close the
control box cover.
NOTE:
When the backup initialization is carried out, the
sewing data values will be reset to the values
shown at left.
11
2. PREPARATION
BAS-705