Setting The Bobbin Counter - Brother BAS-705 Instruction Manual

3. PANEL OPERATION

3-2-2. Setting the bobbin counter

When the bobbin has been replaced, you need to set the number of bar tacking stitches that the
new bobbin can be used for.
The counter setting decreases by 1 each time a single bar tacking is sewn.
The bobbin counter operation can also be disabled if required.
The setting range is 0 - 999.
w
PROGRAM MODE
Production counter
1st bobbin counter
2nd bobbin counter
PROGRAM MODE
Production counter
1st bobbin counter
2nd bobbin counter
PROGRAM MODE
Production counter
1st bobbin counter
2nd bobbin counter
PROGRAM MODE
Production counter
1st bobbin counter
2nd bobbin counter
MODE SELECT
e
,//
,,,
WARNING
CANCEL
ENTER
t
1. Press the MODE switch w to select PROGRAM
mode.
SELECT switches e to move the
2. Use the and
pointer " " so that "1st bobbin counter" or "2nd
bobbin counter" is selected.
3. While using the
cursor "-", press the
e to set the desired bobbin counter setting.
* If the CANCEL switch r is pressed, the old
previously-set bobbin counter setting will appear
again on the display.
4. Press the ENTER switch t
* The new bobbin counter setting will appear on
the display.
To disable operation of the bobbin counter
* Enter "0" as the value when making the bobbin
counter setting.
14
POWER
RESET
r
SELECT switch e to move the
and SELECT switches
BAS-705